There are several others here that you might have success with. In order to get USB 2. It allows for example to copy and replace files which can’t be replaced or deleted when windows is running. Deleting files under ms-dos Mar 25, Is this Post still active? I used Nero to create a couple of boot cds using the floppy as the source for the files and they work fine and the external drive was allocated drive letter D on my p.
|Date Added:||12 November 2010|
|File Size:||45.1 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Join the community hereit only takes a minute.
Can assign only one volume letter, mounts only one the lowest primary partition. Iiomega, such a behaviour is a fault of the device, and a bad sign for usability in DOS.
So there is a USB driver that works with your board. No other Dos Drivers 5. EXE, but nothing else.
They are comparable, both provide not only USB storage support but also USB keyboards, mice, printers and other devices. EHCI itself is not a problem but the hubs behind it, probably That is why i don’t use config. The drivers work in the background and are able to handle more than one USB device at the same time.
SYS to the A: Btw, my motivation to buy and test was the memory bandwidth I’ve been asked to bid on a memory intensive project. Reply – Oct 20 that 5: Yes, my password is: Posted February 18, edited. This handicap prevent the use of plain DOS mode for repairing the system as in w9x.
But obtaining much less in not that uncommon and can have various reasons: Also it’s big leap compared to DDR2. Are there other DOS drivers that you are loading that are not necessary for this specific task?
I was getting a data transfer rate of over mb per min usb2 and 89mb per minute on the lower spec. To all Why is this a better driver–see my reasons at the end of this post.
It also ensure that your machine is perfectly idle at the time you do the axpiehci.sys. Still not ready for an official release yet.
Back to home page DOS ain’t dead Forum index page. Thanks very much for your help Keith Carlisle. I can always change to the other one if I need to.
Well, duffy98, if you have Ghost installed in your Win 98SE, you’ll find the Iomega drivers in the folder. The difference seems to be that Usv is pure USB 2. A Better USB 2.
But I have no access to the memory card until the drivers are first loaded from floppy or bootable CD. Not all USB host controller cards and chips are supported. New Bootable CD Blog. It means you can plug and remove flashdisks without restarting, you can manipulate with content of the flash disk even on another computer and plug it back.
Yes, I replied this here http: So I have copied the Ghost. I went to http: